![ifix scada node on standby ifix scada node on standby](https://www.ge.com/digital/documentation/ifix/version60/Subsystems/redund/content/graphics/scadasyncmon3.gif)
19 Using Historian in a Regulated Environment.
#Ifix scada node on standby archive
14 Configuring Archives.16 Setting Archive Size. 6 Exploring the System Statistics and Message Search Screens. 4 Components of the Historian Administrator.
![ifix scada node on standby ifix scada node on standby](https://static.wixstatic.com/media/dac9cf_f5e278855a2040a886a43270e902d6e9~mv2.gif)
3 Installing the Historian Administrator. 1 Introduction to the Historian Administrator. Table Of Contents Using the Historian Administrator.1 Reference Documents. If you have comments, questions, or suggestions about our documentation, send them to the following email address: Portions of this software are copyrighted by DataDirect Technologies, 1991-2006 We want to hear from you. CIMPLICITY is a registered trademark of GE Fanuc Automation. Any other trademarks herein are used solely for purposes of identifying compatibility with the products of GE Fanuc Automation. Microsoft is a registered trademark of Microsoft Corporation. Notice GE Fanuc Automation reserves the right to make improvements to the products described in this publication at any time and without notice.
#Ifix scada node on standby manual
The user of the information contained in the manual and the software described herein is subject to the GE Fanuc Automation standard license agreement, which must be executed by the buyer or user before the use of such information, equipment or software. GE Fanuc Automation shall not be liable for any damages, including special or consequential damages, arising out of the user of such information, equipment and software, even if GE Fanuc Automation has been advised in advance of the possibility of such damages. The entire risk as to the quality and performance of such information, equipment and software, is upon the buyer or user. Without limiting the foregoing, GE Fanuc Automation disclaims any and all warranties, expressed or implied, including the warranty of merchantability and fitness for a particular purpose, with respect to the information contained in this manual and the equipment or software described herein. However, GE Fanuc Automation assumes no responsibilities for any errors, omissions or inaccuracies whatsoever. Disclaimer of Warranties and Liability The information contained in this manual is believed to be accurate and reliable. No part of this publication may be reproduced in any form or by any electronic or mechanical means, including photocopying and recording, without permission in writing from GE Fanuc Automation.